Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

iDRAC 8/7 v2.30.30.30 User’s Guide

Configuring iDRAC Quick Sync

Using iDRAC web interface or RACADM, you can configure iDRAC Quick Sync feature to allow access to the mobile device:
  • Access — You can specify any of the following options to configure the access state of iDRAC Quick Sync feature:
    • Read-Write — Default status.
    • Read-write access – Allows you to configure the basic iDRAC settings.
    • Read-only access – Allows you to view inventory and monitoring information.
    • Disabled access – Does not allow you to view information and configure settings.
  • Time-out — You can enable or disable iDRAC Quick Sync inactivity timer:
    • If enabled, you can specify a time after which the Quick Sync mode is turned off. To turn on, press the activation button again.
    • If disabled, the timer does not allow you to enter a time-out period.
  • Time-out Limit — Allows you specify the time after which the Quick Sync mode is disabled. The default value is 30 seconds.

You must have Server Control privilege to configure the settings. A server reboot is not required for the settings to take effect.

An entry is logged to the Lifecycle Controller log when the configuration is modified.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\