Treceți la conținutul principal
Deconectare

Bun venit la Dell

Contul meu
  • Plasaţi comenzi rapid şi simplu
  • Vizualizaţi comenzile şi urmăriţi starea transportului
  • Creaţi şi accesaţi o listă cu produsele dvs.
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Autentificare Creaţi un cont Autentificare la Premier Autentificare la programul pentru parteneri
Contactaţi-ne

Dell OptiPlex 9020 Small Form Factor Owner's Manual

PDF

Installing the Power Supply

  1. Place the power supply in the chassis and slide towards the back of the computer to secure it.
  2. Tighten the screws securing the power supply to the back of the computer.
  3. Connect the 4-pin and 8–pin power cables to the system board.
  4. Thread the power cables into the chassis clips.
  5. Install the:
    1. drive cage
    2. optical drive
    3. front bezel
    4. cover
  6. Follow the procedures in After Working Inside Your Computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\