Treceți la conținutul principal
Deconectare

Bun venit la Dell

Contul meu
  • Plasaţi comenzi rapid şi simplu
  • Vizualizaţi comenzile şi urmăriţi starea transportului
  • Creaţi şi accesaţi o listă cu produsele dvs.
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Autentificare Creaţi un cont Autentificare la Premier Autentificare la programul pentru parteneri
Contactaţi-ne

Dell OptiPlex 9020 Small Form Factor Owner's Manual

PDF

Removing the Input/Output (I/O) Panel

  1. Follow the procedures in Before Working Inside Your Computer .
  2. Remove the:
    1. cover
    2. optical drive
    3. drive cage
    4. front bezel
  3. Disconnect the I/O panel or FlyWire cable and the audio cable from the system board.
    Figure displaying how to un-thread the I/O panel or the FlyWire cable from the fan-shelter clip and heat sink
  4. Remove the screw that secures the I/O panel to the chassis. Then, slide the I/O panel to release and remove it from the computer.
    Figure displaying how to remove the single screw that secures the I/O panel to the chassis and remove from the computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\