Dell Vostro 3490 Service Manual

Before working inside your computer

About this task

To avoid damaging your computer, perform the following steps before you begin working inside the computer.

Steps

  1. Ensure that you follow the Safety Instruction.
  2. Ensure that your work surface is flat and clean to prevent the computer cover from being scratched.
  3. Turn off your computer.
  4. Disconnect all network cables from the computer.

    CAUTION: : To disconnect a network cable, first unplug the cable from your computer and then unplug the cable from the network device.

  5. Disconnect your computer and all attached devices from their electrical outlets.
  6. Press and hold the power button while the computer is unplugged to ground the system board.

    NOTE: : To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface at the same time as touching a connector on the back of the computer.


Оценить этот контент

Точно
Функционально
Просто понять
Помогла ли вам эта статья?
0/3000 characters
  Поставьте оценку (1–5 звезд).
  Поставьте оценку (1–5 звезд).
  Поставьте оценку (1–5 звезд).
  Выберите ответ на вопрос, была ли статья полезной.
  Комментарии не должны содержать следующие специальные символы: <>()\