- Notes, cautions, and warnings
- About this guide
- Installing SmartFabric OS10
- Preparing for an upgrade
- Upgrade sequence for SmartFabric OS10 platforms
- Dell SmartFabric OS10 certificate expiration and recommended action
- Supported upgrade paths—Full Switch mode deployments
- Supported upgrade paths—SFS mode deployments
- Supported upgrade paths—Dell PowerEdge MX deployments
- Platform-specific prerequisites and notes
- Prerequisites and notes for solution deployments
- Startup configuration during upgrade or downgrade
- Upgrading OS10 software
- Downgrading OS10 software
- Installation, Upgrade, and Downgrade commands
- Upgrade or downgrade OS10 image on secure boot-enabled nodes
- Update ONIE and ONIE firmware
- Upgrade PCIe firmware from DIAG OS
- Upgrade PCIe firmware from OS10 hshell
- Minimum ONIE Firmware Updater version requirement for OS10 platforms
- Links to ONIE Firmware Updater and DIAG OS Release Notes
- Link to Dell Technologies Innodisk 3IE3 Solid State Drive ONIE Firmware Updater Release Notes
- Frequently asked questions
Dell SmartFabric OS10 Installation, Upgrade, and Downgrade Guide
About this guide
This guide is intended for system administrators who are responsible for installing, upgrading, and maintaining networks. It includes the following chapters:
- Installing SmartFabric OS10
- Preparing for upgrade
- Upgrading OS10 software
- Downgrading OS10 software
- Frequently asked questions
This document may contain language that is not consistent with current guidelines of Dell Technologies. There are plans to update this document over subsequent releases to revise the language accordingly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\