disabling OS to iDRAC Pass-through using web interface
OS to iDRAC Pass-through using Web interface:
iDRAC Settings >
OS to iDRAC Pass-through.
OS to iDRAC Pass-through page
Select any of the following options to enable OS to iDRAC
LOM — The OS to iDRAC pass-through link
between the iDRAC and the host operating system is established through
the LOM or NDC.
USB NIC — The OS to iDRAC pass-through
link between the iDRAC and the host operating system is established
through the internal USB bus.
To disable this feature, select
If you select
LOM as the pass-through
configuration, and if the server is connected using dedicated mode,
enter the IPv4 address of the operating system.
NOTE: If the
server is connected in shared LOM mode, then the
field is disabled.
If you select
USB NIC as the pass-through
configuration, enter the IP address of the USB NIC.
The default value is 169.254.0.1. It is recommended to use the
default IP address. However, if this IP address conflicts with an
IP address of other interfaces of the host system or the local network,
you must change it.
Do not enter 169.254.0.3 and 169.254.0.4 IPs.
These IPs are reserved for the USB NIC port on the front panel when
a A/A cable is used.
Apply to apply the settings.
Test Network Configuration to check if the IP is accessible and the link is established between
the iDRAC and the host operating system.