based on the infrastructure setup, you can use IPv6 address protocol.
To configure the IPv6 settings:
For the DHCPv6 server to automatically assign
the IP address, gateway, and subnet mask to iDRAC, select
Enabled option under
NOTE: You can configure both static IP and DHCP IP at the same
Static IP Address 1 box, enter the static IPv6 address.
Static Prefix Length box, enter a value between 0 and 128.
Static Gateway box, enter the gateway address.
NOTE: If you configure static IP, the current IP address 1 displays
static IP and the IP address 2 displays dynamic IP. If you clear the
static IP settings, the current IP address 1 displays dynamic IP.
If you are using DHCP, enable
to obtain DNS Server addresses
to obtain Primary and Secondary
DNS server addresses from DHCPv6 server. You can configure the following
Static Preferred DNS Server box, enter the static DNS server IPv6 address.
Static Alternate DNS Server box, enter the static alternate DNS server.