- Notes, cautions, and warnings
- Introduction
- Requirements
- Registry Settings
- Install Using the Master Installer
- Uninstall the Master Installer
- Install Using the Child Installers
- Uninstall Using the Child Installers
- Data Security Uninstaller
- Commonly Used Scenarios
- Provision a Tenant
- Configure Advanced Threat Prevention Agent Auto Update
- Pre-Installation Configuration for SED UEFI, and BitLocker Manager
- Designate the Dell Server through Registry
- Extract Child Installers
- Configure Key Server
- Use the Administrative Download Utility (CMGAd)
- Configure Encryption on a Server Operating System
- Configure Deferred Activation
- Troubleshooting
- Glossary
Dell Endpoint Security Suite Enterprise Advanced Installation Guide v3.8
All Clients - Protection Status
A new method for deriving a device's protected status has been implemented in the Dell Server v9.8.2. Previously, the Endpoint Protected Status area in the Management Console's dashboard would only denote the state of Encryption per device.
As of Dell Server v9.8.2, Protected status is now denoted if any of the following criteria have been met:
- Advanced Threat Prevention is installed and enabled.
- Web Protection or Client Firewall is installed and either Web Protection or Client Firewall's policy is enabled.
- Self-Encrypting Drive Manager is installed, enabled, and the PBA is enabled.
- Full Disk Encryption is installed, enabled, and the PBA is enabled.
- BitLocker Manager is installed, enabled, and encryption has completed.
- Dell Encryption (Mac) is installed and enabled, and Encrypt Using FileVault for Mac has been enforced.
- Dell Encryption (Windows) is installed, enabled, Policy-Based Encryption has been set for the endpoint, and device sweeps are completed.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\