Dell OpenManage Server Administrator Version 8.5 CIM Reference Guide

PDF

CIM_PhysicalMemory

CIM_PhysicalMemory

The CIM_PhysicalMemory class listed in PhysicalMemoryProperties is a subclass of CIM_Chip, representing low-level memory devices, such as SIMMs, DIMMs, and so on.

Table 1. CIM_PhysicalMemory Properties . The following table describes the properties and data type of the CIM PhysicalMemory class.
Class Name: CIM_PhysicalMemory Parent Class:CIM_Chip

Property	Description	Data Type
FormFactor	See Chip Properties	uint16
MemoryType	Indicates the type of physical memory. Values for the MemoryType property are: 0 - Unknown 1 - Other 2 - DRAM 3 - Synchronous DRAM 4 - Cache DRAM 5 - EDO 6 - EDRAM 7 - VRAM 8 - SRAM 9 - RAM 10 - ROM 11 — Flash 12 - EEPROM 13 - FEPROM 14 - EPROM 15 - CDRAM 16 - 3DRAM 17 - SDRAM 18 - SGRAM 19 - RDRAM 20 - DDR 21 - DDR2 22 - DDR2 FB-DIMM 24 - DDR3 25 - FBD2 26 - DDR4	uint16
TotalWidth	Indicates the total width, in bits, of the physical memory, including check or error correction bits. If there are no error correction bits, the value in this property should match that specified for the DataWidth property.	uint16
DataWidth	Indicates the data width, in bits, of the physical memory. A data width of 0 and a total width of 8 would indicate that the memory is solely used to provide error correction bits.	uint16
Speed	Indicates the speed of the physical memory, in nanoseconds.	uint32
Rank	The Rank values of DIMM are: 0 - Unknown 1 - Single 2 - Dual 4 - Quad 8 - Octal 16 - Hexa	unit32
SpeedAsString	Indicates the accurate speed of the physical memory, in string format (with units).	string
Capacity	Indicates the total capacity of this physical memory, in bytes.	uint64
BankLabel	A string identifying the physically labeled bank where the memory is located, for example, "Bank 0" or "Bank A."	string
PositionInRow	Specifies the position of the physical memory in a “row.” For example, if it takes two 8-bit memory devices to form a 16-bit row, then a value of 2 means that this memory is the second device. 0 is an invalid value for this property.	uint32
InterleavePosition	Indicates the position of this physical memory in an interleave. 0 indicates noninterleaved. 1 indicates the first position, 2 the second position, and so on. For example, in a 2:1 interleave, a value of 1 indicates that the memory is in the “even” position.	uint32
Manufacturer	Indicates the manufacturer of the physical memory.	string
SerialNumber	Indicates the serial number of the physical memory.	string