Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Inspiron 15 5000 Service Manual

Procedure

About this task

NOTE Ensure that the touch pad is aligned with the guides available on the palm-rest and keyboard assembly, and the gap on either sides of the touch pad is equal.

Steps

  1. Align the screw holes on the touch pad with the screw holes on the palm rest and keyboard assembly.
  2. Replace the screws that secure the touch pad to the palm rest and keyboard assembly.
  3. Adhere the status-light board cable to the touch pad.
  4. Align the screw holes on the touch-pad bracket with the screw holes on the palm rest and keyboard assembly.
  5. Replace the screws that secure the touch-pad bracket to the palm rest and keyboard assembly.
  6. Adhere the tape that secures the touch pad to the palm rest and keyboard assembly.
  7. Slide both ends of the touch-pad cable into their respective connectors and close the latches to secure the cable.
  8. Slide the keyboard backlight cable into the connector and close the latch to secure the cable.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\