- Notes, cautions, and warnings
- Working on your computer
- Removing and
installing components
- Recommended tools
- Back cover
- Front Bezel
- Opening the front panel door
- Storage
- Removing 3.5–inch hard drive assembly
- Removing 3.5–inch hard drive from the hard drive bracket
- Installing the 3.5–inch hard drive into the hard drive bracket
- Installing 3.5–inch hard drive assembly
- Removing the 2.5–inch drive assembly
- Removing the 2.5–inch drive from the drive bracket
- Installing the 2.5–inch hard drive into the hard drive bracket
- Installing the 2.5-inch drive assembly
- Optical drive
- M.2 PCIe SSD
- SD card reader
- Memory module
- Expansion card
- Power supply unit
- VGA daughter board
- Intrusion switch
- Power switch
- Speaker
- Coin cell battery
- Heat sink assembly
- Processor
- System fan
- System board
- M.2 Intel Optane Memory Module 16 GB
- Technology and components
- System setup
- Software
- Troubleshooting your computer
- Technical specifications
- Processor specifications
- Memory specifications
- Video specifications
- Audio specifications
- Communication specifications
- Storage specifications
- Ports and connectors specifications
- Power supply specifications
- Physical dimension specifications
- System board layout
- Controls and lights specifications
- Environmental specifications
- Contacting Dell
OptiPlex 7050 Tower Owner's Manual
Troubleshooting
- The Intel Optane Memory model name "NVME INTEL MEMPEK1W01" in Device
Manager does not match in the Intel Rapid Storage Technology user
interface; it only shows a part of the serial number information.
This is a known issue and does not impede the functionality of the
Intel Optane Memory.
Device Manager: NVME INTEL MEMPEK1W01
IRST UI: INTEL MEMPEK1W016GA
- During the first-time boot up, the system
will scan the pairing status as below screen shot after shutdown.
It’s working as designed and the message will not appear again in
following boot ups.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\