Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge MX740c Installation and Service Manual

PDF

Removing the Jumbo PERC card

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your sled.
  3. Disconnect the cable connected to the Jumbo PERC card.

Steps

  1. Pull the two blue pull tags to raise the lever up on the Jumbo PERC card.
  2. Holding both the blue pull tags, lift the Jumbo PERC card away from the system.
  3. Install the connector cap on the I/O connector of the Jumbo PERC card.
    Figure 1. Removing the Jumbo PERC card
    This image shows how to remove the Jumbo PERC card.
    NOTE When Jumbo PERC is installed in the mini Mezzanine slot, you cannot install any other controller cards in the mini Mezzanine slot.
    NOTE The Jumbo PERC card controls the internal drives, and the storage sled drives mapped to the storage controller.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\