Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge R430 Owner's Manual

Inside the system

CAUTION Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
Figure 1. Inside the system—with a cabled power supply
This figure shows inside of the system with a cabled power supply.
  1. control panel
  2. cable routing latch
  3. power supply unit
  4. expansion-card riser connector (2)
  5. memory-module socket (B3, B4)
  6. processor 2
  7. memory-module socket (B1, B2)
  8. memory-module socket (A1, A5, A2, A6)
  9. processor 1
  10. memory-module socket (A3, A7, A4, A8)
  11. cooling fan (5)
  12. optical drive (optional)
Figure 2. Inside the system—with redundant power supplies
This figure shows inside of the system with redundant power supplies.
  1. control panel
  2. hard drive/SSD backplane
  3. cable routing latch
  4. power interposer board
  5. power supply units (2)
  6. PCIe expansion card riser (optional)
  7. memory-module socket (B3, B4)
  8. processor 2
  9. memory-module socket (B1, B2)
  10. memory-module socket (A1, A5, A2, A6)
  11. processor 1
  12. memory-module socket (A3, A7, A4, A8)
  13. cooling fan (6)
  14. hard drives/SSDs
  15. optical drive

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\