Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R640 Installation and Service Manual

PDF

Installing the network daughter card

Prerequisites

Follow the safety guidelines listed in Safety instructions.

Steps

  1. Orient the NDC so that the Ethernet connectors fit through the slot in the chassis.
  2. Align the captive screws at the back-end of the card with the screw holes on the system board.
  3. Press the touch points on the card until the card connector is firmly seated on the system board connector.
  4. Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC to the system board.
    Figure 1. Installing the network daughter card
    This image shows installing network daughter card.

Next steps

  1. Install the expansion card riser 2 or the rear drive cage, depending on the configuration of your system.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\