Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell EMC PowerEdge R640 Installation and Service Manual

Removing an expansion card riser

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Before removing the expansion card riser 2A, remove the expansion card from the riser, if installed.
  4. Disconnect any cables connected to the expansion card.

Steps

Hold the touch points, and lift the expansion card riser, from the riser connector, on the system board.
NOTE:While removing the riser 1B, press the tabs and hold the touch point to lift the expansion card riser from the system board.
Figure 1. Removing the expansion riser 1B
This image shows removing the expansion riser 1B
Figure 2. Removing the expansion riser 1A
This image shows removing the expansion riser 1A
Figure 3. Removing the expansion riser 2A
This image shows removing the expansion riser 2A
Figure 4. Removing the expansion riser 2B
This image shows removing the expansion riser 2B

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\