For ease of removal of the right control
panel, remove the cooling fan #8 to access the cable latch.
Lift the cable latch and disconnect the control panel cable from
the connector on the system board.
NOTE: Ensure that you note
the routing of the cables as you remove them from the system board.
You must route the cables properly when you replace them to prevent
the cables from being pinched or crimped.
Using a Phillips #1 screwdriver, remove the screws that secure the cable cover to the system.
Figure 1. Removing the
Using a Phillips #1 screwdriver, remove the screw that secures the control panel to the system.
Figure 2. Removing right
Holding by the sides, remove the right control panel away from the system.
Holding the control panel by its sides, remove the
control panel away from the system.