In the left pane, click
Chassis
Overview
>
Storage >
Controllers >
Troubleshooting.
On the
Controller Troubleshooting page, from the
Actions drop-down list for
the respective controller, select any one of the following, and then
click
Apply.
Reset Configuration — Deletes the virtual
disks and hots spares. However, the data on the disks is not erased.
Export TTY Log — The TTY debug log from
the storage controller is exported to your local system.
Discard Pinned Cache — Deletes data that
is stored in RAID controller cache.
NOTE: If there is pinned
cache, the option to clear it is present. If there is no pinned cache,
this option is not displayed.
Disable RAID Controller — Disables the
peer controller. This option is available in the drop-down menu only
for the Integrated 2 PERC when it is not disabled.
Enable RAID Controller — Enables the peer
controller. If the Integrated 2 PERC is already disabled, then the
Enable Raid Controller option is available in the drop-down
menu.
NOTE:
For a disabled PERC, none of the other options Reset Configuration,
Export TTY Log, Discard Pinned Cache, and Disable RAID Controller
are available in the drop-down menu.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\