You can use the Serial Communication screen to view the properties of the serial communication port.
About this task
You can view
the Serial Communication screen by clicking System Setup Main Menu > System BIOS > Serial Communication.
The Serial Communication screen details are explained below.
Menu Item
Description
Serial Communication
Selects serial communication devices (Serial Device 1 and Serial
Device 2) in the BIOS. BIOS console redirection can also be enabled
and the port address can be specified. By default, Serial
Communication option is set to Auto.
Serial Port Address
Enables you to set the port address for serial devices. By default,
the Serial Port Address option is set to Serial Device 1=COM2, Serial Device 2=COM1.
NOTE:Only Serial Device
2 can be used for Serial Over LAN (SOL). To use console redirection
by SOL, configure the same port address for console redirection and
the serial device.
External Serial Connector
Enables you to associate the external serial connector to serial
device 1, serial device 2, or remote access device. By default, the External Serial Connector option is set to Serial Device1.
NOTE:Only Serial Device
2 can be used for SOL. To use console redirection by SOL, configure
the same port address for console redirection and the serial device.
Failsafe Baud Rate
Displays the failsafe baud rate for console redirection. The BIOS
attempts to determine the baud rate automatically. This failsafe baud
rate is used only if the attempt fails and the value must not be changed.
By default, the Failsafe Baud Rate option is
set to 115200.
Remote Terminal Type
Sets the remote console terminal type. By default, the Remote Terminal Type option is set to VT 100/VT
220.
Redirection After Boot
Enables or disables the BIOS console redirection when the operating
system is loaded. By default, the Redirection After Boot option is set to Enabled.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\