SCv3000 and SCv3020 Storage System Deployment Guide

Review iSCSI Fault Domains

Use the iSCSI - Fault Domain Review page to view the automatically generated fault domain configurations.

1. If the wizard displays an error message about iSCSI port cabling, correct the issue with the cabling and click (Regenerate) to regenerate the iSCSI fault domains.
2. Select the fault domain on which to specify IP addresses for the target and controller ports.
3. Click Set IPv4 Addresses for Fault Domain.
   The Set IPv4 Addresses for Fault Domain dialog box opens.
4. Type the target address for the iSCSI control port in the Target IPv4 Address field.
5. Type the subnet mask of the iSCSI network in the Subnet Mask field.
6. Type the IP address of the iSCSI network default gateway in the Gateway IPv4 Address field.
7. To set IP addresses for the iSCSI ports:
   1. Select a port to edit.
   2. Click (Edit).
   3. Type the IP address for the port in the IPv4 Address field.
   4. Click Set.
      Repeat the previous steps to add additional ports to the fault domain.
8. Click OK.
   Repeat the previous steps for the other fault domains.
9. Click Next.
10. View the iSCSI fault domains that have been created, and click Next.