- Notes, cautions, and warnings
- Copyright
- Introduction
- Preinstallation
Setup
- Prerequisite Checker
- Installation Requirements
- Configuring SNMP Agents
- Secure Port Server And Security Setup
- Remote Enablement Requirements
- Installing Managed
System Software On Microsoft Windows Operating Systems
- Deployment Scenarios
For Server Administrator
- Installer Location
- Installing Server Administrator
- System Recovery On Failed Installation
- Upgrading Managed System Software
- Uninstalling Managed System Software
- Deployment Scenarios
For Server Administrator
- Installing Managed System Software On Microsoft Windows Server and Microsoft Hyper-V Server
- Using Microsoft
Active Directory
- Active Directory Schema Extensions
- Extending The Active Directory Schema
- Frequently Asked Questions
Dell EMC OpenManage Installation Guide — Microsoft Windows Version 9.1
Installing Server Administrator
This section explains how to install the Server Administrator and other managed system software using two installation options:
- Using the setup program at \SYSMGMT\srvadmin\windows on the Dell EMC OpenManage Systems Management Tools and Documentation software.
- Using the unattended installation method through the Windows Installer Engine msiexec.exe.
- NOTE: SNMP service is stopped and started during Systems Management installation and uninstallation. As a result, other third-party services, dependent on SNMP stop. If the third-party services are stopped, manually restart the services.
- NOTE: For Blade systems,install Server Administrator on each server module installed in the chassis.
- NOTE: During installation of Server Administrator on supported Windows systems, if an Out of Memory error message is displayed, exit the installation and free up memory. Close other applications or perform any other task that frees up memory, before reattempting Server Administrator installation.
-
NOTE: If you use the
MSI file to try to install Server Administrator on a system where
the
User Account Control settings is set to a greater level,
the installation fails and displays a message:
Server Administrator
installation program could not install the HAPI driver
. You
must perform the installation process as an administrator. You can
also install Server Administrator successfully by the following methods:
- Click the setup.exe file, or
- Right-click , and then run the installer command in CLI mode. For more information on CLI mode, see Installing Managed System Software In CLI Mode
The setup program invokes the prerequisite checker, which uses the system's Peripheral Component Interconnect (PCI) bus to search for installed hardware such as controller cards.
The Systems Management installer features a Typical Setup option and a Custom Setup option for installing Server Administrator and other managed system software.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\