Dell OpenManage SNMP Reference Guide for iDRAC and Chassis Management Controller
iDRAC Traps
The iDRAC generates events that result in Simple Network Management Protocol (SNMP) traps and/or entries in the iDRAC Lifecycle Log. This section describes the traps, also known as alerts, generated by the iDRAC.
The iDRAC generates events in response to changes in the status of sensors and other monitored parameters. When an event with predefined characteristics occurs on your system, the SNMP subagent sends information about the event, along with trap variables, to the management console.
Each event generates an identifier called the trap ID and a list of trap variables that provide additional details about the event. The trap variables are listed in the following on Trap Variables.
The traps of the iDRAC MIB are organized into five subgroups of
traps. Each subgroup corresponds to one of the five categories of
events that iDRAC supports (the
System Health,
Storage Health,
Updates, Audit, and
Configuration categories). Here is a
list of the trap subgroups are:
- System Trap Group
- Storage Trap Group
- Updates Trap Group
- Audit Trap Group
- Configuration Trap Group
The trap subgroups, and all the traps within each trap subgroup,
are described and listed in sections following the
Trap Variables section.
- NOTE: The traps listed in this document can be correlated to specific events that are documented in the Dell Event Message Reference guide. There is 1-to-many relationship between SNMP traps and events in iDRAC. To correlate a trap to a specific event or set of events, you can match the Trap ID value of a trap in this document to the Trap/Event ID value of events in the Dell Event Message Reference guide.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\