- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the base cover
- Replacing the base cover
- Removing the battery
- Replacing the battery
- Removing the memory modules
- Replacing the memory modules
- Removing the hard drive
- Replacing the hard drive
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the wireless card
- Replacing the wireless card
- Removing the keyboard
- Replacing the keyboard
- Removing the palm-rest assembly
- Replacing the palm-rest assembly
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the status-light board
- Replacing the status-light board
- Removing the fans
- Replacing the fans
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the I/O board
- Replacing the I/O board
- Removing the system board
- Replacing the system board
- Removing the heat sink
- Replacing the heat sink
- Removing the speakers
- Replacing the speakers
- Removing the subwoofer
- Replacing the subwoofer
- Removing the display assembly
- Replacing the display assembly
- Removing the display bezel
- Replacing the display bezel
- Removing the display panel
- Replacing the display panel
- Removing the camera
- Replacing the camera
- Removing the display cable
- Replacing the display cable
- Removing the display hinge and bracket assembly
- Replacing the display hinge and bracket assembly
- Removing the display back-cover and antenna assembly
- Replacing the display back-cover and antenna assembly
- Flashing the BIOS
- Diagnostics
- Getting help and contacting Dell
Inspiron 15 5000 Gaming Service Manual
Procedure
- Slide the display cable into the connector on the display panel and close the latch to secure the cable.
- Adhere the tape that secures the display cable to the display panel.
- Turn the display panel over and gently place it on the display back-cover and antenna assembly.
- Align the screw holes on the display panel with the screw holes on the display back-cover and antenna assembly.
- Replace the four screws (M2x3) that secure the display panel to the display back-cover and antenna assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\