Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge C4130 Owner's Manual

Removing the intrusion switch

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified service technicians.

  1. Follow the safety guidelines listed in safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Ensure that the GPU power and signal cables do not interfere with the intrusion switch cable.

Steps

  1. Disconnect the intrusion switch cable from the connector on the system board.
  2. Slide the intrusion switch out of the intrusion switch slot.
    Figure 1. Removing the intrusion switch
    This figure shows removing the intrusion switch.
    1. intrusion switch slot
    2. intrusion switch
    3. intrusion switch cable

Next steps

  1. Install the intrusion switch.
  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\