- Notes, cautions, and warnings
- About this document
- Dell EMC PowerEdge C4140 system overview
- Initial system setup and configuration
- PowerEdge C4140 installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Air shroud
- Cooling fans
- Hard drives
- Intrusion switch
- System memory
- Expansion cards and expansion card risers
- Processor and heat sink
- Network daughter card
- System battery
- Optional internal USB memory key
- Graphics processing unit
- PCIe Graphics processing unit
- GPU installation guidelines
- Removing a GPU riser cable from the GPU switch board
- Removing a GPU
- Removing a GPU riser cable board
- Removing the GPU brackets from the GPUs removed from your system
- Removing the GPU brackets from the replacement GPUs
- Removing the GPU switch board
- Installing the optional GPU switch board
- Installing the custom GPU brackets on the replacement GPUs
- Installing the GPU brackets on the GPUs removed from your system
- Installing a GPU riser cable board
- Installing a GPU
- Installing a GPU riser cable on the GPU switch board
- GPU cabling diagrams
- SXM2 Graphics processing unit
- Power supply units
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics
- Getting help
- Documentation resources
Dell EMC PowerEdge C4140 Installation and Service Manual
Jumpers and connectors
This topic provides specific information about the jumpers. It also provides some basic information about jumpers and switches and describes the connectors on the various boards in the system. Jumpers on the system board help to disable the system and setup passwords. You must know the connectors on the system board to install components and cables correctly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\