The RACADM command-line utility provides a scriptable
interface that allows you to locally configure or remotely configure
your CMC. The utility runs
on the management station and the managed system. It is available
on the Dell OpenManage Systems Management and Documentation DVD or at dell.com/support.
The RACADM utility supports the following interfaces:
SSH or Telnet — Also known as Firmware RACADM. Firmware
RACADM is accessible by logging in to CMC using SSH or Telnet.
Similar to Remote RACADM, at the RACADM prompt, directly run the commands
without the RACADM prefix.
Remote — Supports running RACADM commands from a
remote management station such as a laptop or desktop. To run Remote
RACADM commands, install the DRAC Tools utility from the OpenManage
software on the remote computer. To run Remote RACADM commands:
Formulate the command as a SSH or Telnet RACADM command.
For more information about the options, see RACADM Subcommand
Details. To download the local RACADM tool from dell.com/support, click Servers, Storage & Networking in
the General Support section. Click PowerEdge, click the required PowerEdge system, and then
click Drivers & downloads.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\