Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell Chassis Management Controller Version 6.0 for PowerEdge M1000e User’s Guide

PDF

Configuring Initial CMC Network

NOTE Changing the CMC network settings may disconnect the current network connection.
You can perform the initial network configuration of CMC before or after CMC has an IP address. To configure CMC’s initial network settings before you have an IP address, you can use either of the following interfaces:
  • The LCD panel on the front of the chassis
  • Dell CMC serial console
To configure initial network settings after CMC has an IP address, you can use any of the following interfaces:
  • Command line interfaces (CLIs) such as a serial console, Telnet, SSH, or the Dell CMC console through iKVM
  • Remote RACADM
  • CMC Web interface

CMC supports both IPv4 and IPv6 addressing modes. The configuration settings for IPv4 and IPv6 are independent of one another.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\