Dell Chassis Management Controller Version 6.0 for PowerEdge M1000e User’s Guide

Configuring Network Settings for IOMs Using CMC Web Interface

1. In the system tree, go to I/O Module Overview and click Setup or expand I/O Module Overview, select the IOM, and click Setup.
   The Deploy I/O Modules page displays the IOMs that are powered on.
2. For the required IOMs, enable DHCP, enter the IP address, subnet mask, and gateway address.
3. For IOMs that are manageable, enter root password, SNMP RO Community string, and Syslog Server IP Address. For information about the fields, see CMC Online Help.
   NOTE The IP address set on the IOMs from CMC is not saved to the switch's permanent startup configuration. To save the IP address configuration permanently, you must enter the connect switch-n command, or racadm connect switch -n RACADM command, or use a direct interface to the IOM GUI to save this address to the startup configuration file.

   NOTE The SNMP community string can have any printable character whose ASCII value is the range, 33–125.
4. Click Apply.
   The network settings are configured for the IOM(s).

   NOTE For IOMs that are manageable, you can reset the VLANs, network properties, and IO ports to default configurations.