CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized
in your product documentation, or as directed by the online or telephone
service and support team. Damage due to servicing that is not authorized
by Dell is not covered by your warranty. Read and follow the safety
instructions that came with the product.
Remove the blade from the sleeve.
WARNING: The processor and heat sink can become extremely hot. Be sure the
processor has had sufficient time to cool before handling.
CAUTION: Never
remove the heat sink from a processor unless you intend to remove
the processor. The heat sink is necessary to maintain proper thermal
conditions.
Loosen the two retention sockets that secure the heat sink
to the blade system board.
Remove the heat sink.
Figure 1. Removing and
Installing a Heat Sink
heat sink
retention sockets (2)
retention screws (2)
Use a clean, lint-free cloth to remove any thermal grease
from the surface of the processor shield.
CAUTION: The processor is held in its socket under strong pressure. Be aware
that the release lever can spring up suddenly if not firmly grasped.
Position your thumb firmly over the processor socket-release
lever and release the lever from the locked position. Rotate the lever
90 degrees upward until the processor is released from the socket.
Use the tab on the processor shield to rotate the processor
shield upward and out of the way.
If applicable, remove the socket protective cap from the
processor shield. To remove the socket protective cap, push the cap
from the inside of the processor shield and move it away from the
socket pins.
NOTE: It is recommended
that you install/remove the socket protective cap from the processor
shield with the processor shield in the open position.
CAUTION: The
socket pins are fragile and can be permanently damaged. Be careful
not to bend the pins in the socket when removing the processor out
of the socket.
Lift the processor out of the socket and leave the release
lever up so that the socket is ready for the new processor.
CAUTION: If you are permanently removing a processor, you must install a socket
protective cap and a processor/DIMM blank in the vacant socket to
ensure proper system cooling. The processor/DIMM blank covers the
vacant sockets for the DIMMs and the processor.
NOTE: For more information
on installing a processor/DIMM blank, see Removing A Processor/DIMM
Blank.
Figure 2. Removing and
Installing a Processor
processor
processor shield
notches in the processor (4)
socket keys (4)
pin-1 indicator (on the processor socket)
pin-1 indicator (on the processor)
socket-release lever
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\