Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge M420 Systems Owner's Manual

PDF

Removing The Management Riser Card

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Remove the blade from the sleeve.
  2. Remove the cards from the SD card and vFlash card slots.
  3. Remove the mezzanine card/blank.
  4. Remove the SSDs.
    • NOTE: If you are removing both SSDs, label them so you can replace them in their original locations.
  5. Remove the SSD backplane.
  6. Remove the blade system board.
  7. Remove the three screws from the management riser card.
  8. Lift the management riser card away from the blade system board.
    Figure 1. Removing and Installing the Management Riser Card The figure shows removing and installing the management riser card.
    1. management riser card
    2. screws (3)
    3. system configuration jumpers
    4. management riser card connector

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\