Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FC430 Owner's Manual

PDF

Removing an internal SD card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

  3. Enter System Setup and ensure that the Internal SD Card Port is enabled.

NOTE: When an SD card failure occurs, on the next reboot, the system displays a message indicating the failure.

Steps

  1. Locate the SD card slot on the internal dual SD module (IDSDM) card.
  2. Press the card to release it from the slot and remove the card.
    Figure 1. Replacing an internal SD card
    This figure shows removing an internal SD card.
    1. SD card slot
    2. SD card

Next steps

  1. Follow the procedure listed in the After working inside your system section.

  2. Enter System Setup and ensure that the Internal SD Card Port is enabled.

  3. Check if the new SD card is functioning properly. If the problem persists, see the Troubleshooting an Internal SD Card section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\