Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

debug gvrp

Enable debugging on GVRP.

Syntax

debug gvrp {config | events | pdu}

To disable debugging, use the no debug gvrp {config | events | pdu} command.

Parameters

config	Enter the keyword `config` to enable debugging on the GVRP configuration.
event	Enter the keyword `event` to enable debugging on the JOIN/LEAVE events.
pdu	Enter the keyword `pdu` then one of the following Interface keywords and slot/port or number information: For a Port Channel interface, enter the keywords `port-channel` then a number. The range is from 1 to 128. For a 10-Gigabit Ethernet interface, enter the keyword `TenGigabitEthernet` then the slot/port information.

Defaults

Disabled.

Command Modes

EXEC

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.