Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

mac-address-table static

Associate specific MAC or hardware addresses to an interface and virtual local area networks (VLANs).

Syntax

mac-address-table static mac-address output interface vlan vlan-id

To remove a MAC address, use the no mac-address-table static mac-address output interface vlan vlan-id command.

Parameters

mac-address	Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn format.
output interface	Enter the keyword `output` then one of the following interfaces for which traffic is forwarded: For a Port Channel interface, enter the keywords `port-channel` then a number. The range is from 1 to 128. For a 10-Gigabit Ethernet interface, enter the keyword `TenGigabitEthernet` then the slot/port information.
vlan vlan-id	Enter the keyword `vlan` then a VLAN ID number from 1 to 4094.

Defaults

Not configured.

Command Modes

CONFIGURATION

Supported Modes

Programmable-Mux (PMUX)

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.