Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge FC430 Owner's Manual

Troubleshooting processors

Steps

  1. Turn off the sled using the operating system commands or the CMC.
  2. Remove the sled from the enclosure.
  3. Ensure that the processor(s) and heat sink(s) are properly installed.
  4. If your system has only one processor installed, ensure that it is installed in the primary processor socket (CPU1).
  5. Install the sled in the enclosure.
  6. Turn on the sled.
  7. Run the appropriate diagnostic test. For more information, see the Using system diagnostics section.
    If the problem persists, see the Getting help section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\