Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FC830 Owner's Manual

PDF

Removing the NDC

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTE: You must remove the NDC to replace a faulty NDC or service other components inside the system.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

  3. Keep the #2 Phillips screwdriver ready.

  4. Remove the PCIe mezzanine card.

Steps

  1. Remove the two screws that secure the Network Daughter Card (NDC) to the system board.
    CAUTION: To prevent damage to the NDC, hold the card only by its edges.
  2. Lift the card away from the system.
    Figure 1. Removing the NDC
    This figure shows removing the NDC.
    1. slot on the NDC
    2. screw (2)
    3. NDC
    4. standoff (2)
    5. connector
    6. tab projections

Next steps

  1. Install the NDC.

  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\