Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

clear dampening

Clear the dampening counters on all the interfaces or just the specified interface.

Syntax

clear dampening [ interface]

Parameters

interface

(OPTIONAL) Enter any of the following keywords and slot/port or number to clear counters from a specified interface:

For a Port Channel interface, enter the keywords port-channel then a number. The range is from 1 to 128.
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

Defaults

Without an interface specified, the command clears all interface dampening counters.

Command Modes

EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the M I/O Aggregator.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

On the switch, after you enter the clear counters command and verify the results with the show interfaces command, the line rate is not reset to 0.00%.

Example

Dell#clear dampening tengigabitethernet 1/2
                                             Clear dampening counters on tengig 1/2 [confirm] y
                                             Dell#

Related Commands

show interfaces dampening — displays interface dampening information.

dampening — configures dampening on an interface.