Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

match route-type

To match routes based on the how the route is defined, configure a filter.

Syntax

match route-type {external [type-1 | type-2] | internal | local}

Parameters

external [type-1\| type-2]	Enter the keyword `external` then either type-1 or type-2 to match only on OSPF Type 1 routes or OSPF Type 2 routes.
internal	Enter the keyword `internal` to match only on routes generated within OSPF areas.
local	Enter the keyword `local` to match only on routes generated within the switch.

Defaults

Not configured.

Command Modes

ROUTE-MAP

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Related Commands

match interface — redistributes routes that match the next-hop interface.

match ip address — redistributes routes that match an IP address.

match ip next-hop — redistributes routes that match the next-hop IP address.

match ip route-source — redistributes routes that match routes advertised by other routers.

match metric — redistributes routes that match a specific metric.

match tag — redistributes routes that match a specific tag.