Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

remark

Enter a description for an ACL entry.

Syntax remark [ remark-number] [ description]
Parameters
remark-number Enter the remark number. The range is from 0 to 4294967290.
  • NOTE: You can use the same sequence number for the remark and an ACL rule.
description Enter a description of up to 80 characters.
Defaults Not configured.
Command Modes
  • CONFIGURATION-IP ACCESS-LIST-STANDARD
  • CONFIGURATION-IP ACCESS-LIST-EXTENDED
  • CONFIGURATION-MAC ACCESS LIST-STANDARD
  • CONFIGURATION-MAC ACCESS LIST-EXTENDED
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The remark command is available in each ACL mode. You can configure up to 4294967290 remarks in a given ACL.

The following example shows the use of the remark command twice within CONFIGURATION-STANDARD-ACCESS-LIST mode. The same sequence number was used for the remark and for an associated ACL rule. The remark precedes the rule in the running-config because it is assumed that the remark is for the rule with the same sequence number, or the group of rules that follow the remark.

Example 
Dell(conf-std-nacl)#remark 10 Deny rest of the traffic
                                             Dell(conf-std-nacl)#remark 5 Permit traffic from XYZ Inc.
                                             Dell(conf-std-nacl)#show config
                                             !
                                             ip access-list standard test
                                             remark 5 Permit traffic from XYZ Inc.
                                             seq 5 permit 1.1.1.0/24
                                             remark 10 Deny rest of the traffic
                                             seq 10 Deny any
                                             Dell(conf-std-nacl)#
Related Commands resequence access-list — Re-assigns sequence numbers to entries of an existing access-list.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\