Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show ip bgp ipv6 unicast summary

Allows you to view the status of all BGP connections.

Syntax

show ip bgp ipv6 unicast summary

Command Modes

EXEC
EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The following describes the show ip bgp ipv6 unicast summary command shown in the Example below.

Field	Description
BGP router identifier	Displays the local router ID and the AS number.
BGP table version	Displays the BGP table version and the main routing table version.
network entries	Displays the number of network entries, route paths, and the amount of memory used to process those entries.
BGP path attribute entries	Displays the number of BGP path attributes and the amount of memory used to process them.
BGP AS-PATH entries	Displays the number of BGP AS_PATH attributes processed and the amount of memory used to process them.
BGP community entries	Displays the number of BGP COMMUNITY attributes processed and the amount of memory used to process them. The `show ip bgp ipv6 unicast community` command provides more details on the COMMUNITY attributes.
Dampening enabled	Displayed only when dampening is enabled. Displays the number of paths designated as history, dampened, or penalized.
Neighbor	Displays the BGP neighbor address.
AS	Displays the AS number of the neighbor.
MsgRcvd	Displays the number of BGP messages that neighbor received.
MsgSent	Displays the number of BGP messages that neighbor sent.
TblVer	Displays the version of the BGP table that was sent to that neighbor.
InQ	Displays the number of messages from that neighbor waiting to be processed.
OutQ	Displays the number of messages waiting to be sent to that neighbor. If a number appears in parentheses, the number represents the number of messages waiting to be sent to the peer group.
Up/Down	Displays the amount of time (in hours:minutes:seconds) that the neighbor is in the Established stage. If the neighbor has never moved into the Established stage, the word never is displayed.
State/Pfx	If the neighbor is in Established stage, the number of network prefixes received. If a maximum limit was configured with the `neighbor maximum-prefix` command, (prfxd) appears in this column. If the neighbor is not in Established stage, the current stage is displayed (Idle, Connect, Active, OpenSent, OpenConfirm). When the peer is transitioning between states and clearing the routes received, the phrase (Purging) may appear in this column. If the neighbor is disabled, the phrase (Admin shut) appears in this column.

Example

Dell#show ip bgp ipv6 unicast summary
                                             BGP router identifier 5.5.10.4, local AS number 100
                                             BGP table version is 12, main routing table version 12
                                             2 network entrie(s) and 4 paths using 536 bytes of memory
                                             1 BGP path attribute entrie(s) using 112 bytes of memory
                                             1 BGP AS-PATH entrie(s) using 39 bytes of memory
                                             Dampening enabled. 0 history paths, 0 dampened paths, 0 penalized paths
                                             
                                             Neighbor   AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/Pfx
                                             
                                             5ffe:10::3  1    28     0       12   0     0 00:01:01   2
                                             5ffe:11::3  1    27     0       12   0     0 00:00:55   2
                                             Dell#