Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FX2 and FX2s Enclosure Owner's Manual

PDF

Removing the power interposer board

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTE: This is a field replaceable unit (FRU). Removal and installation procedures should be performed only by Dell certified service technicians.
  1. Ensure that you read the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the midplane assembly.

Steps

  1. Remove the Mylar insulator.
  2. Disconnect the power bus bar and the cable cover from the midplane assembly.
  3. Disconnect the power bus bar and the cable cover from the power interposer board.
  4. Remove the four screws that secure the power interposer board to the carrier.
  5. Lift the power interposer board from the carrier.
    Figure 1. Removing and installing the power interposer board
    This figure shows removing and installing the power interposer board.
    1. screw (4)
    2. power interposer board
    3. carrier

Next steps

Install the power interposer board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\