跳至主要內容
登出

歡迎來到 Dell

我的帳戶
  • 簡單快速地下訂單
  • 檢視訂單及追蹤商品運送狀態
  • 建立並存取您的產品清單
  • 使用「公司管理」來管理您的 Dell EMC 網站、產品和產品層級連絡人。
登入 建立帳戶 Premier 登入 合作夥伴計畫登入
與我們連絡

您的 Dell.com 購物車

Dell PowerEdge R750 Installation and Service Manual

PDF

Removing the expansion card risers

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the air shroud or remove the GPU air shroud.
  4. NOTE:If the BOSS S2 module is installed, ensure to disconnect the BOSS S2 power cable and Signal cable before removing the Riser 1 cage.
    Figure 1. BOSS S2 module with power cables
    Removing the BOSS power cable and BOSS signal cable from the BOSS S2 controller card module
  5. If applicable, disconnect the cables from the expansion card or system board.

Steps

  1. Loosen the captive screws on the riser.
  2. Press the blue release tab or blue button on the riser and holding the edges lift the expansion card riser from the riser connector on the system board.
    NOTE:图像上的数字不能准确描述具体步骤。这些数字只是为了表示顺序。
    Figure 2. Removing the expansion card riser (Riser 1)
    This image shows Removing the expansion card riser (Riser 1).
    Figure 3. Removing the expansion card riser (Riser 3)
    This image shows Removing the expansion card riser (Riser 3).
    Figure 4. Removing the expansion card riser (Riser 2)
    This image shows Removing the expansion card riser (Riser 2).
    Figure 5. Removing the expansion card riser (Riser 4)
    This image shows Removing the expansion card riser (Riser 4).
  3. If the risers are not going to be replaced, install riser blanks and if required tighten the captive screws.
    NOTE:You must install a filler bracket over an empty expansion card slot to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
    Figure 6. Installing the Riser 1 blank
    This image shows Installing the Riser 1 blank
    Figure 7. Installing the Riser 2 blank
    This image shows Installing the Riser 2 blank
    Figure 8. Installing the Riser 3 blank
    This image shows Installing the Riser 3 blank
    Figure 9. Installing the Riser 4 blank
    This image shows Installing the Riser 4 blank

對此內容評分

準確
實用
易懂
這篇文章對您有用嗎？
0/3000 characters
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  本文章是否有幫助？請選擇。
  評語中不得包含下列特殊字元：<>()\