Removal
Left side cover
Identify the left side cover highlighted in blue.
Loosen the captive screw that secures the left side cover latch to the chassis.
Pull on the left side cover latch to release the left side cover from the chassis.
Remove and lift the left side cover from the chassis.
Graphics card end holder
Identify the graphics card end holder highlighted in blue.
Slide the release latch to its unlock position and lift the graphics card end holder away from the front chassis fan.
Graphics card
Identify the graphics card highlighted in blue.
Press and hold the securing clip on the graphics card power cable, then pull the connector off the graphics card.
Lift the pull tab and open the expansion card door.
Push the securing tab on the PCIe slot on the system board away from the graphics card.
Grasp the card by its top corner and ease it out of the slot.
Power supply unit
Identify the power supply unit highlighted in blue.
Disconnect the system board power cable to the system board.
Disconnect the graphics card power cables from the power supply unit.
Press down on the securing clips to disconnect the power supply cables from the processor power cables.
Unroute the power supply unit cables from the routing guides on the chassis.
Remove the screws that secure the power supply cage to the chassis.
Slide and lift the power supply cage off the chassis.
Remove the screws that secure the power supply unit to the chassis.
Slide and lift the power supply unit off the chassis.
Install
Power supply unit
Identify the power supply unit location highlighted in blue.
Place the power supply unit on the chassis and align with screw holes.
Install the screws that secure the power supply unit to the chassis.
Align and place the power supply unit bracket on the power supply unit.
Install the screws that secure the power supply unit bracket to the power supply unit.
Route the power supply cables through the routing guides on the chassis.
Connect the power supply cables to the processor power cables.
Connect the graphics card power cables to the power supply unit.
Connect the system board power cable to the system board.
Graphics card
Identify the graphics card location highlighted in blue.
Place the card into the PCIe slot and press down firmly until the single graphics card snaps into place.
Close the expansion door and snap the latch back into position.
Connect the graphics card power cable to the graphics card.
Graphics card end holder
Identify the graphics card end holder location highlighted in blue.
Install the graphics card end holder over the front chassis fan and slide the latch into its lock position.
Left side cover
Identify the side cover location highlighted in blue.
Slide the bottom edge of the left side cover into the chassis.
Push the left side cover into place.
Tighten the captive screw that secures the left side cover latch to the chassis.