Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the screws that secure the base cover to the palm rest assembly.
Remove the screws that secure the base cover to the palm rest assembly.
Pry the base cover near the hinges. Pry from recess points near the hinges.
Loosen the base covery by working on the left, right and, top sides to open the base cover.
Lift and remove the base cover off the palm rest assembly.
Battery Cable
Identify the battery cable highlighted in blue.
Disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Display Assembly
Identify the display assembly highlighted in blue.
Remove the screws that secure the left and right display hinges to the system.
Open the display hinges at an angle of 90 degrees.
Lift the latch and disconnect the display cable from the system board.
Lift the palm rest assembly at an angle to free it from the hinges and remove it from the display assembly.
Install
Display Assembly
Place the display assembly on a clean and flat surface
Identify the display assembly location highlighted in blue.
Slide and place the palm rest assembly at an angle on the display assembly.
Close the display hinges and align with the screw holes.
Install the screws that secure the left and right display hinges to the system.
Connect the display cable to the system board. Close the latch to secure.
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the system board.
Base Cover
Identify the base cover location highlighted in blue.
Place the base cover on the system and snap into place.
Tighten the screws that secure the base cover to the system.
Install the screws that secure the base cover to the system.