Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the captive screws that secure the base cover.
Remove the screws that secure the base cover to the system.
Using a plastic scribe, pry the basecover from bottom left to loosen.
Slide and lift the base cover off the system.
Battery Cable
Identify the battery cable highlighted in blue.
Peel the tape that secure the battery cable to the battery.
Disconnect the battery cable from the system board.
Press and hold the power button for 20 seconds to ground the system and remove residual static electricity.
Rear I/O Cover
Identify the rear I/O cover highlighted in blue.
Remove the screws on the back of the system that secure the rear I/O cover.
Disconnect the tron light cable from the system board.
Remove the screws that secure the rear I/O cover to the system.
Push the rear cover away from the system and lift it off the system.
Top heatsink
Identify the top heatsink highlighted in blue.
Remove the screws that secure the top heatsink.
Lift the top heatsink off the system.
Power adapter port
Identify the power adapter port highlighted in blue.
Peel the tape, lift the metal latch and disconnect the display cable from the system board.
Unroute the display cable from the power adapter port latch.
Remove the screws that secure the power adapter port bracket.
Remove the power adapter port bracket from the system.
Disconnect the power adapter port cable from the system board.
Lift the power adapter port and peel the cable from the system board.
Install
Power adapter port
Identify the power adapter port location highlighted in blue.
Install the power adapter port into the slot and adhere the cable to the system board.
Connect the power adapter port cable to the system board.
Install the bracket over the system.
Install the screws to secure the power adapter port bracket.
Route the display cable through the power adapter port latch.
Connect the display cable to the system board and close the latch to secure. Adhere the tape to secure.
Top heatsink
Identify the top heatsink location highlighted in blue.
Place the top heatsink on the system board.
Install the screws to secure the top heatsink.
Rear I/O Cover
Identify the rear I/O cover location highlighted in blue.
Slide the rear cover towards the system till it snaps into place.
Install the screws that secure the rear I/O cover to the system.
Connect the tron light cable to the system board.
Install the screws that secure the rear I/O cover on the back of the system.
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the connector on the system board.
Base Cover
Identify the base cover location highlighted in blue
Slide and align the base cover and press the edges of the cover until it clicks into place.
Tighten the captive screws that secure the base cover to the system.
Install the screws that secure the base cover.