Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the captive screws that secure the base cover.
Remove the screws that secure the base cover to the system.
Using a plastic scribe, pry the basecover from bottom left to loosen.
Slide and lift the base cover off the system.
Battery Cable
Identify the battery cable highlighted in blue.
Using the pull tab, disconnect the battery cable from the system board.
Press and hold the power button for 20 seconds to ground the system and remove residual static electricity.
Rear I/O Cover
Identify the rear I/O cover highlighted in blue.
Remove the screws on the back of the system that secure the rear cover.
Remove the screws that secure the left and right tron light cables to the system board.
Disconnect the rear I/O cables from the system board.
Push the rear cover away from the system and lift it off the system.
Power adapter port
Identify the power adapter port highlighted in blue.
Remove the screws that secure the power adapter port bracket.
Remove the power adapter port bracket from the power adapter port.
Disconnect the power adapter port cable from the system board.
Peel the tape that secures the power adapter port cable to the the fan and heat sink assembly.
Lift the power adapter port and peel the cable from the system board.
Install
Power adapter port
Identify the power adapter port location highlighted in blue.
Install the power adapter port into the slot and adhere the cable to the system board.
Connect the power adapter port cable to the system board.
Adhere the tape that secures the power adapter port to the fan and heat sink assembly.
Install the bracket over the power adapter port.
Install the screws to secure the power adapter port bracket.
Rear I/O Cover
Identify the rear I/O cover location highlighted in blue.
Slide the rear cover towards the system till it snaps into place. Be cautious of the plastic clips under the cover to make sure they are aligned.
Connect the rear I/O cables to the system board.
Install the screws that secure the left and right tron light cables to the system board.
Install the screws that secure the rear cover on the back of the system.
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the connector on the system board.
Base Cover
Identify the base cover location highlighted in blue.
Slide and align the base cover and press the edges of the cover until it clicks into place.
Tighten the captive screws that secure the base cover to the system.
Install the screws that secure the base cover.