This 3D experience gives you the step by step process of replacing the Memory Modules and a Optiplex Micro 3070. The procedure will also include removing the Base Cover, System Fan and reinstalling them.
Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the thumbscrew that secures the cover to the system.
Slide and lift the cover to remove from the system.
System Fan
Identify the system fan highlighted in blue.
Press the blue tabs on both sides of the system fan to release.
Turn the system fan over to remove it from the system. The fan cable does not need to be unplugged.
Memory Modules
Identify the memory module highlighted in blue.
Separate the securing clips from the memory module until the memory module pops up.
Remove the memory module from the socket on the system board.
Install
Memory Modules
Identify the memory module location highlighted in blue.
Align the notch on the memory module with the tab on the slot and slide the memory into the slot at an angle.
Press the memory module down until it clicks into place.
System Fan
Identify the system fan location highlighted in blue.
Install the system fan and slide the system fan until it clicks into place.
Base Cover
Identify the base cover location highlighted in blue.
Place the cover on the system and slide the cover until it clicks into place.
Tighten the thumb screw to secure the cover to the system.