Removal
Side Cover
Identify the side cover highlighted in blue.
Loosen the captive screws that secure the side cover to the chassis.
Slide the side cover towards the back and lift it from the system.
Front Bezel
Identify the front bezel highlighted in blue.
Gently pry and release the front bezel tabs sequentially from the top.
Rotate the front bezel outward from the chassis and remove the front bezel.
Hard drive assembly
Identify the hard drive carrier highlighted in blue.
Disconnect the data and power cables from the hard drive.
Remove the screws that secure the hard drive carrier to the chassis.
Slide the hard drive carrier out of the disk drive cage by moving it away from the chassis, then lift it out.
HDD and Optical Drive Bracket
Identify the disk drive cage highlighted in blue.
Remove the screw to release the disk drive cage from the chassis..
Lift the disk drive and detach it from the mounting points on the chassis.
Rotate the drive cage and place it on the chassis.
Lift the disk drive cage away from the computer.
Solid State Drive (SSD) 2230
Identify the solid state drive (SSD) highlighted in blue.
Remove the screw that secures the SSD to the system board.
Slide and lift the SSD from the system board.
Install
Solid State Drive (SSD) 2230
Identify the solid state drive (SSD) location highlighted in blue.
Align the notch with the tab and slide the SSD into the connector on the system board.
Install the screw that secures the SSD to the system board.
HDD and Optical Drive Bracket
Identify the disk drive cage location highlighted in blue.
Place the disk drive cage upside down on the chassis.
Hold the disk drive cage upright and match its mounting points with the slots on the chassis.
Align the screw hole on the cage with the screw hole on the chassis.
Install the screw to secure the disk drive cage in place.
Hard drive assembly
Identify the hard drive carrier location highlighted in blue.
Align the tabs on the hard drive carrier with the slots on the chassis and snap the hard drive carrier onto the disk drive cage.
Install the screws to secure the hard drive carrier to the chassis.
Connect the data and power cables to the connectors on the hard drive.
Front Bezel
Identify the front bezel location highlighted in blue.
Align the front cover tabs with the slots on the chassis.
Insert the front cover into the slots on the chassis and rotate the front cover towards the chassis and snap it into place.
Side Cover
Identify the side cover location highlighted in blue.
Slide the side cover towards the front of the system until you hear the release latch click.
Tighten the captive screws that secure the side cover to the chassis.