Removal
BOSS S2 - card carrier
Identify the BOSS S2 card carrier highlighted in blue.
Pull and lift the BOSS S2 card carrier retention latch lock to open.
Slide the BOSS S2 card carrier out.
System Cover
Identify the system cover highlighted in blue.
Using a 1/4 inch flat head or a phillips #2 screwdriver rotate the lock counterclockwise to the unlock position.
Lift the release latch until the system cover slides back.
Lift the cover from the system.
BOSS S2 module
Identify the BOSS S2 module highlighted in blue.
Disconnect the BOSS S2 power and signal cable from the BOSS S2 module.
Using the phillips #1 screwdriver remove the screw that secures the BOSS S2 module on Riser 1.
Slide the BOSS S2 module towards the front of the chassis and lift the module.
Install
BOSS S2 module
Identify the BOSS S2 module location highlighted in blue.
Align the BOSS S2 module at an angle with the controller card module slot.
Insert the BOSS S2 module and push the module horizontally towards the rear of the system until firmly seated.
Using the phillips #1 screwdriver, install the screw that secures the BOSS S2 module to the system.
Connect the BOSS S2 power and signal cable to the connectors on the BOSS S2 module.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system and slide the system cover.
Close the system cover release latch.
Using a 1/4 inch flat head or phillips #2 screwdriver, rotate the lock clockwise to the lock position.
BOSS S2 - card carrier
Identify the BOSS S2 card carrier location highlighted in blue.
Slide the BOSS S2 card carrier into the BOSS S2 module slot.
Close the BOSS S2 card carrier release latch to lock the carrier in place.