Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Low profile right riser assembly
Identify the low profile right riser highlighted in blue
Loosen the captive screw that securing the riser to the system board.
Hold the touch points and lift the low profile right riser assembly from the system board.
LOM Riser Card
Identify the LOM riser card highlighted in blue
Remove the screws that secure the LAN on Motherboard (LOM) riser card to the system board.
Push apart the two blue plastic clips securing the LOM riser card to release the riser.
Hold the LOM riser card by the edges on either side, and lift to remove it from the connector on the system board.
Slide the LOM riser card towards the front of the system until the Ethernet connectors or the SFP+ are clear of the slot in the back panel and Lift the LOM riser card out of the system.
System Battery (Coin Cell)
Identify the system battery highlighted in blue
Use a plastic scribe to pry out the system battery.
Lift the battery out of the socket.
Install
System Battery (Coin Cell)
Identify the system battery location highlighted in blue
Install the battery with the "+" facing up and slide it under the securing tabs.
Press the battery into the connector until it snaps into place.
LOM Riser Card
Identify the LOM riser card location on the system board.
Orient the LOM riser card to fit the Ethernet connectors or the SFP+ through the slot of the bracket.
Press the LOM riser card until the card is firmly seated on the system board connector and the two blue plastic clips to secure the LOM riser card in place.
Replace the screws to secure the LOM riser card to the system board.
Low profile right riser assembly
Identify the low profile right riser location highlighted in blue
Lower the low profile right riser assembly into place until it is fully seated in the connector on the system board.
Tighten the captive screw to secure the riser to the system board.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.