Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Airshroud
cooling fan cage assembly
Identify the Cooling Fan Assembly highlighted in blue.
Lift the blue release levers to unlock the cooling fan cage assembly from the system.
Hold the release levers, and lift the cooling fan cage assembly away from the system.
Front Bezel
Identify the front bezel highlighted in blue
Unlock the front bezel by using the key.
Press the release button, and pull the left end of the front bezel.
Unhook the right end, and remove the front bezel.
Backplane
Identify the hard drive backplane highlighted in blue
Slide and lift the backplane cover in the direction of the arrows marked on the backplane cover.
Press the release button to open the release handle.
Holding the handle, slide the drive carrier out of the drive slot.
Disconnect the cables from the backplane.
Disconnect the cable from the rear mount front PERC module.
Press the blue release tabs and lift the backplane to disengage the backplane from the hooks on the system.
Lift and pull the drive backplane out of the system.
Install
Backplane
Identify the hard drive backplane location highlighted in blue
Use the guides on the system as guides to align the slots on the backplane.
Insert the backplane into the guides and lower the backplane until the blue release tabs clicks into place.
Connect the cable to the rear mount front PERC module.
Connect the cables to the backplane.
Insert the drive carrier into the slot and slide until it connects with the backplane.
Close the drive carrier release handle to lock the drive in place.
Slide the backplane cover toward the front of the system until the cover locks into place.
Front Bezel
Identify the front bezel location highlighted in blue
Hook the right end of the front bezel onto the system.
Fit the free end of the front bezel onto the system.
Lock the front bezel by using the key.
cooling fan cage assembly
Identify the Cooling Fan Assembly location highlighted in blue.
Align the guide rails on the cooling fan cage assembly with the standoffs on the system.
Lower the cooling fan cage assembly into the system until the cooling fan cage connectors engage with the connectors on the system board.
Press the release levers to lock the cooling fan cage assembly into the system.
Airshroud
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.