Removal
Stand
Identify the stand highlighted in blue.
Press and hold down on the tab that secures the stand to the display assembly base.
Slide and lift the stand off the display assembly base.
Back Cover
Identify the back cover highlighted in blue.
Press down on the tab and slide the back cover to release.
Lift the back cover off the display assembly base.
System Board Shield
Identify the system board shield highlighted in blue.
Remove the screws that secure the system board shield to the display assembly base.
Lift the system board shield off the display assembly base.
Heat Sink
Identify the heat sink highlighted in blue.
Loosen the captive screws that secure the heatsink. Loosen in reverse sequential order.
Lift the heat sink off the system board.
Use the alcohol pad to clean the heatsink (as shown in the video).
Install
Heat Sink
Identify the heat sink location highlighted in blue.
Apply a pea sized amount of thermal material as shown.
Install the heatsink into the slot on the system board.
Tighten the captive screws that secure the heat sink. Tighten in order. Do not over tighten.
System Board Shield
Identify the system board shield location highlighted in blue.
Place the system board shield on the display assembly base and align with screw holes.
Install the screws that secure the system board shield to the display assembly base.
Back Cover
Identify the back cover location highlighted in blue.
Align the back cover to the display assembly base.
Place and slide the back cover into place on the display assembly base.
Stand
Identify the stand location highlighted in blue.
At an angle, align the tabs on the stand with the slots on the display assembly base.
Slide the stand into place into the slot on the display assembly base.